Drawing with sizes To make things easy, I made some drawings. First you have to cut all the wooden parts according to the diagrams. I was using 4×2 foot, 1.5 cm (0.6 inch) thick plywood and two 4×2 foot 0.5cm (0.2 inch) triplex board. For the frame you need two laths of 210cm (82.6 inches) length.
The workbench top is pinewood 1.8cm (0.7 inch) thick. I started with a piece 40cm x 100cm (15.7 inches x 40 inches) and cut this into two halves. The piano hinge joined the 50cm edges so that the finished (open) size was 50cm x 80cm. The other materials are aluminium tubes and aluminium strip; see the drawing.
Next you have to make the 2 toolboxes. Photo 2 shows the frame and photo 3 the boxes with rear and bottom pieces installed. All parts have to be cut precisely. After that it needs planing and sanding.
After the 2 boxes, the four drawers can be made. Bottom and side parts are 15mm (0.6 inch) thick plywood. They are screwed together. Front and back parts are 0.5cm (0.2 inch) triplex board. Small nails connect these parts to the bottom and the side. Always apply construction glue before connecting the parts.
The drawers have to slide easily into and out of the box. To make that happen I made side and bottom slats from wood. You can also use modern drawer slides. I like simple solutions. The top drawers are actualy two tilt trays. This is better for carrying heavy tools. Block the tilt tray with a screw so it
